Only the whole width of the structure is intended for the mezzanine floor. Engineering design is required if a partial mezzanine is required. If the structure is planned with a mezzanine floor, the floor can be added before or after the structure’s frame is completed. The mezzanine stairs builder and the size of the structure would decide this. In large structures, the finished floor may be utilized to install rafters and complete roofing without the need for scaffolding. like Aw Structures, Without the need for scaffolding, the completed floor may be utilized to install rafters and complete the roofing.
The mezzanine bearer bracket will be one 6mm plate per connection, regardless of whether the bearer is double or single, and should be mounted on side wall columns during the initial assembly of the side walls.
The column is braced to the desired bearing height. The bearer height criteria may be found in the engineering plans. When building the columns and haunch brackets, it is advised that the mezzanine floor brackets be fixed.
Connect the mezzanine floor bearing to the well before mezzanine floor brackets when the building frames are complete and in position. Double bearers must be punched and bolted together at regular intervals, according to the software’s (Multi build) punching standards.
Stair trimmers can now be installed
This example stair plan should only be used as a reference due to the various variants available and specific requirements. Refer to the “Stairwell Void Plan Options” document attached if the stairs’ specs change from this sample layout. Engineering design is necessary for unique stair arrangements. The ideal way to build and install the staircase is on the ground. Because of the stair angle and the likelihood of minor deviations, stair treads and stringers are not punched.
To accommodate the stair angle, stair stringers must be plumb cut at the top and bottom. Fix the stringer in place for now to identify the places and levels of the stair treads. As shown on the “Steel Staircase Layout” document, install angle cleats to both ends of each stair step. Lay the stringer flat, place each tread in its proper location, and mark the location of the bolt holes.
Mezzanine floor, S-case & S-well TIP:-
The use of smaller pilot holes in the center of each mark will make the work easier while drilling these holes. For the second-stringer, the stringer can be utilized as a template. After all of the holes have been drilled, tighten the treads.
Mezzanine floor, S-case & S-well CAUTION:-
Before using, the step treads should be wrapped with abrasive non-slip tape or something similar. The staircase may now be moved into place and supported with the help of additional installers. Install masonry anchors through the base cleat at the bottom end of each stringer and bolt to the rear bearer.
Read More: Parquet Flooring Can Give You a Perfect Floor Look in Your Home
Conclusion:-
Check the completed mezzanine floor, staircase, and stairwell void one more time. Make sure all of the foundation cleats are securely fastened. Make sure all bolts are in place and tight. To ensure safety, hose off the concrete slab to remove any dust, screws, and rivets.
Before installing the floor materials, double-check that the structure is complete and that all fasteners are in place and tensioned. The flooring should be fastened to the joists according to the manufacturer’s instructions.
